Worm gear reducer compact structure small volume due to the use of planetary transmission principle, the input shaft output shaft in the same axis line, so that its model to obtain as small as possible size.

The reducer operates smoothly and has low noise. The cycloid needle teeth are more meshing teeth, the overlap coefficient is large and the mechanism of parts balance is great, so that the vibration and noise are limited to the minimum degree.

Worm gear worm reducer hand vibration cause:

1. The connection part of the reducer and the motor is not vertical, resulting in resonance. The motor must be removed and installed again.

2. If the output shaft connected with the reducer is bent or changed, the coaxiality of the output transmission shaft must be tested.

3. If the center height of the equipment transmission shaft is inconsistent with that of the reducer, the installation surface of the reducer must be adjusted to ensure that the two installation dimensions of the equipment transmission shaft and the reducer are equal.

The worm gear of the worm provides the answer to an effective application of power transmission requiring high ratio deceleration in limited Spaces using right-angle (90°), non-crossing shafts. When used correctly, worms and gear provide the smoothest, quietest form of balance sheet.

Because the efficiency of a worm gear and worm drive depends on the starting lead Angle and amount on the worm, improving efficiency, as always is a goal, the ratio should be kept as low as possible. Normal operation, worm and worm gear used together, must have the same diameter spacing and thread.